1ggte dizzy ms-1 v3.0 no spark to cyls 456

**boardmaniscool** · 08-10-2007, 06:15 PM

im trying to get my 1ggte gen 3 engine to start of a ms-1 ive wired up running the extra spark thinggy.
the coil is out puting plenty of sparks but after going through the dizzy it only fires the first 3 cyls ?
and its one of them stuffed up dizzys that fires 123 off one arm and 456 off another.
thanks.

**thechuckster** · 08-10-2007, 08:02 PM

which G sensors (in the dizzi) are you using for the home signal?

and you are getting 6 sparks from the coil but only three being distributed out to plugs?

can you post a log file from Megatune?

have you put up a thread on msextra.com with log file and the msq?

**boardmaniscool** · 08-10-2007, 08:31 PM

Originally Posted by thechuckster

which G sensors (in the dizzi) are you using for the home signal?

and you are getting 6 sparks from the coil but only three being distributed out to plugs?

can you post a log file from Megatune?

have you put up a thread on msextra.com with log file and the msq?

yep im getting all the sparks i need from the dizzy and the taco on the coil and the ms read the same.
im using the 24 tooth wheel with 2 teeth cut out.

i think the prob is in or with the dizzy ?
thanks

**The Real Roadrunner** · 08-10-2007, 08:42 PM

have a look at the rotor button and if it is the type with a resistor under all the resin,

if so diegrind out the resin and replace that section with a bit of copper soldered in (or similar) and fill it up with silicone so it doesn't vibrate out.

had to do this with the two ive fitted autronic's to but havn't found out why.

cheers
linden